forum.datacad.com

I use datacad 14 and am helping out a friend with some drawings. I wanted to know how to reset the polar angle so 90 degrees is up and zero degrees is to the right. I use relative polar on all my other drawings and they work correctly. I did change the input to relative input but when I try to input a line at 45 degrees it goes to the left and not right.

How do I change or reset this to the default.

Thanks
Paul

Paul -

Go to Utility/Settings/Angle Type/Start Angle. Pick your starting point and drag to the right to set the angle to zero.

Thanks
its one of those items that I have set once and then use a seed file for new sheets.

PJM