Hey guys I have a situation where I need to mark a slanted post parallel to the ground plane of it's current location for a cut line that will be cut later once dug up. I was trying to think of a way or device that would allow me to set the height of the cut line off the adjacent ground plane and trace around the post. My other idea is a laser level and manually marking the post, but I am not sure I can get that to work since the cut line is just a little more than an inch off the ground and I think my laser level would be too high, I haven't check it yet. I was thinking of some sort of wheeled device that might hold a marking pen. The red plane and grey plane are parallel. Any ideas?
Attachments
Plane Cut.PNG (8.4 KiB) Viewed 9789 times
Thanks! - Josh
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned.
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned.