Post off topic threads here.
#71047 by Bob Ruger
Thu Mar 23, 2017 12:58 pm
I am running DataCAD in Windows 10 in a virtual machine (Fusion 8) on a mac. Up till now window updates installed without problems. The last update went completely wrong as both size and resolution were completely off. Size was smaller than the monitor screen and I could not reset resolution to what it was before (2560x1440). I successfully reverted back to version 1511 and all is now as it was. But why did this happen? Should I update again as this was maybe just a fluke? Has this happened to anyone else? Thanks.

Bob
#71058 by Neil Blanchard
Fri Mar 24, 2017 10:07 am
Since you do not depend on Windows updates for system security, I would not update Windows, unless and until something is broken. Since, you are also dependent on Fusion, it may be that it needs an update before Windows can be updated.

I have a Windows 10 machine at home, and have no issues with updates.

Who is online

Users browsing this forum: No registered users and 12 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984