DataCad for printed circuit boards
Posted: Thu Jan 26, 2023 8:07 pm
I am looking at making an intervalometer for a camera - this in the absence of anybody so much smarter than me that they actually know what is required. I am coming to the conclusion that it is actually cheaper to get a circuit board made than it is to wire up a prototyping board, not to mention a lot less stressful.
Making up the "artwork" for a PCB in DataCad is easy enough, I know essentially what it should look like. The objective now is to convert DataCad to gerber files.
Has anybody had experience with that?
Making up the "artwork" for a PCB in DataCad is easy enough, I know essentially what it should look like. The objective now is to convert DataCad to gerber files.
Has anybody had experience with that?