Post off topic threads here.
#10271 by Neil Blanchard
Sun Mar 05, 2006 4:04 pm
Hello,

You can either go to the Control Panel/Add/Remove Programs and if it is listed there, go ahead and remove it; or if that doesn't work, you could try to restore an earlier system Registry. Start/Programs/Accessories/System Tools/System Restore -- this should let you load an earlier Registry; back before you installed the Tai interface. But it will also roll back any other software that you might have installed since then, as well.
#10272 by Sun Devil
Sun Mar 05, 2006 4:33 pm
Thank You Neil. I've restored the system and it works fine now. You're the best.

Who is online

Users browsing this forum: No registered users and 78 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984