Need advice on hardware? Ask questions and share your opinions here.
#69980 by MtnArch
Sat Oct 15, 2016 1:57 am
I'm partial to NVidia.
#69982 by jimgoodman
Sat Oct 15, 2016 8:24 am
I'm an NVidia guy as well..
(must be a left coast thing)
#69992 by Ted B
Mon Oct 17, 2016 11:10 am
I've always used Nvidia cards and had good luck -- and performance -- with them, though the breadth of Nvidia cards is bewildering.
#69993 by joshhuggins
Mon Oct 17, 2016 12:08 pm
Nvidia has been rock solid forever. ATI burned me about 3 times with cards prematurely dying. And don't even get me started on their drivers. For 2D Datacad you don't need much. Running up to a single 1920x1080 screen or dual monitors lower than 1920x1080 I'd go with something that has 2GB of ram. Running dual 1920x1080 monitors or higher you are going to want to get into the 4GB range. If you won't be doing any heavy 3D something like a Nvidia 640-740 series range should work fine. Don't go down into the 610,620,710,720 series. Things tend to get pretty weak in that realm. I prefer EVGA branded Nvidia cards these days. They are just work hard and are priced to compete. If you are going to get into 3D seriously, then you might want to check you most demanding 3D app's recommended requirements, which would probably put you into the Nvidia Quadro line of cards, but that would be outside Datacad land.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984