Need advice on hardware? Ask questions and share your opinions here.
#444 by NJBrian32
Mon Feb 21, 2005 2:38 pm
Our firm is deciding on a new printer and/or copier. Does anyone have any experience with an Oce TDS-300 or a KIP 2001? We were also thinking of just getting the KIP 1880 and living with the plotter we have. What are your opinions please?
-Thanks
Brian
#447 by Brian Engebretson
Mon Feb 21, 2005 3:48 pm
We recently bought a Xerox 510 dp and I really like it. If I remember correctly, it was cheaper than the Oce, but a little more than the KIP depending on options. We got the 10 D size pages per minute version with a color scanner. I think the Oce is used by quite a few repro companies and is a great machine. I don’t think you could go wrong with one of those. I would like to have Oce’s “instant on” capabilities. It only takes a couple minutes for the Xerox to warm up if it’s been idle for a while, but it always seems to be when I need something quickly. We decided on the Xerox because we had an older version, the 8830, for about 5 years and it worked well for us. So we just upgraded to the new model. Sorry I don’t have more specific info on the two machines you are looking at, but I don’t think you would be disappointed by either of them. It just comes down to cost. If the prices are close, I would vote for the Oce.
#500 by Rocket468
Tue Feb 22, 2005 1:31 pm
We have a kip 4000 at our office. It's a couple years old. We run couple hundred feet a day thru it. Got to change out rolls almost evey day. I like the fact that there are folders you can drop your image files like tif, pdf, plt etc in and it prints them right out. We use a print driver that saves a tif image on your computer so it can be viewed in photoshop easy and marked up in there.

I am not sure how many feet it runs a minute. Usually all the sets 50ish sheets take less than 5mins. So its probley 10 sheets a minute there abouts.

Once you flip the switch and windows boots up on the printer it does not take longer than 5 secs for it to start printing once you hit print.

One thing I don't like is the controler is Nt only. I was told a 2000/xp driver is suposta be out someday but they don't seem to be in a hurry.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984