forum.datacad.com

There is this contractor we have worked with and they asked us if we had any suggestions on an inexpensive wide fomat plotter for limited printing of drawings. I recommended the HP 110c which is only $1050 to $1250 new. Does any one have any comments (good or bad) about this plotter? Also does anyone have any recommendations on another plotter?

Thanks to all that can help.

Unless they are dead-set on a new printer, they could always pick up a used plotter (like the HP 450c we've been talking about in another thread) - in fact, there's a 36" wide 450c on Ebay right now for $499 including shipping, cartridges and a roll of paper!

I sent them the link to the website hpdesignjet.com that has used plotters from the other post. Thanks for the advice.