Are there extended codes to set the state for Curves, Polyline, Voids, Create New on/off? If not, could we got some please?
Also the
https://www.datacad.com/ddn/extended_cha ... codes.html list is missing the following items,
1071 : KnockOut for Curves On
1072 : KnockOut for Curves Off
1073 : KnockOut Border for Curves On
1074 : KnockOut Border for Curves Off
1075 : KnockOut for Polygons and Slabs On
1076 : KnockOut for Polygons and Slabs Off
1077 : KnockOut Border for Polygons and Slabs On
1078 : KnockOut Border for Polygons and Slabs Off
and has this message at the bottom of the page.
[an error occurred while processing this directive]