To all,
I've had some circumstances on the current project whereby I've religiously grouped certain items & when revisited for editing/moving etc I've found they have mysteriously become ungrouped, to much annoyance..
Apart from doing something fundamentally wrong, I just can't figure out why this is happening. The only thing I can remember last time was moving a whole sectional profile to another layer. I'm aware when you copy stuff you can keep groups, which I do for grouped items.
Any ideas what could be the cause of this little annoyance will be most appreciated.
________________________________________________________________________________________
Further to the above, I confirm grouped items become ungrouped when moving to another layer. I'm sure they remained grouped before, but will bow to any DataCAD experts who can shed some light on this.
Over & out,
Clayton.
I've had some circumstances on the current project whereby I've religiously grouped certain items & when revisited for editing/moving etc I've found they have mysteriously become ungrouped, to much annoyance..
Apart from doing something fundamentally wrong, I just can't figure out why this is happening. The only thing I can remember last time was moving a whole sectional profile to another layer. I'm aware when you copy stuff you can keep groups, which I do for grouped items.
Any ideas what could be the cause of this little annoyance will be most appreciated.
________________________________________________________________________________________
Further to the above, I confirm grouped items become ungrouped when moving to another layer. I'm sure they remained grouped before, but will bow to any DataCAD experts who can shed some light on this.
Over & out,
Clayton.
Trotman & Taylor Architectural Consultants U.K.