OK Ladies and Gents, 27 years on DCAD and I'm really stumped.
Have a solid fill that's LT MGTA under White Text, on the screen everything's OK but when I go to Print Preview the text changes to BLACK...????
Yes TTF
Text and Fill are on separate layers
Yes "Map fill colors to pen colors" checked
Bitmaps and Fills "Print First" checked
New Pen Table (saved from edited v16 original)
Only four colors, White 1, Red 4, Lt Mgta 2, Dk Gray 3, all 0.25 and 100% w/ colors matched
Pen Sort is off, WYSIWYG on
Printer in "FoxIt Reader PDF Printer", no change using "PDF-XChange Printer 2012"
Funny thing is when I change the text to Red on Lt Mgta Fill it's fine, switch back to White on Lt Mgta and it goes back to black.
Someone knows what's going on, Dave G.?
Have a solid fill that's LT MGTA under White Text, on the screen everything's OK but when I go to Print Preview the text changes to BLACK...????
Yes TTF
Text and Fill are on separate layers
Yes "Map fill colors to pen colors" checked
Bitmaps and Fills "Print First" checked
New Pen Table (saved from edited v16 original)
Only four colors, White 1, Red 4, Lt Mgta 2, Dk Gray 3, all 0.25 and 100% w/ colors matched
Pen Sort is off, WYSIWYG on
Printer in "FoxIt Reader PDF Printer", no change using "PDF-XChange Printer 2012"
Funny thing is when I change the text to Red on Lt Mgta Fill it's fine, switch back to White on Lt Mgta and it goes back to black.
Someone knows what's going on, Dave G.?
Last edited by Stuart Jackson on Wed Aug 19, 2015 9:34 pm, edited 2 times in total.