Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#67983 by dennisnorton
Sat Jan 09, 2016 10:14 am
I have a louvered door as a symbol, with the louvers being drawn as hatch pattern ANSI31 scale 448. For some reason when I insert the symbol into my drawing (normal/full scale) the hatching pattern is way too large. I have never had this occur before. Have I inadvertently toggled something somewhere?

I tried locking the scale and origin in the symbol, but that didn't work either.

Who is online

Users browsing this forum: No registered users and 38 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984