I have a question. I did something unusual - I started a new drawing from scratch, using a default drawing that is our office "standard". Usually, we start with a DWG we inherited from a previous project, or a CAD drawing that was "traced" from a scanned blueprint, or something like that.
I drew the floor plan, and then started a section drawing, and XRef'd the floor plan into it. And I see 4 little + that are included in the extents:
What are those from, and how can I make them go away?
I drew the floor plan, and then started a section drawing, and XRef'd the floor plan into it. And I see 4 little + that are included in the extents:
What are those from, and how can I make them go away?