Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#68985 by wvar
Tue May 24, 2016 1:37 am
Anyone else find that cleaning up smart walls using 1 Line or 2 Line Trim doesnt always work. I have found that to be especially the case when moving walls to another layer and then attempting a trim. Yes the walls are on the same layer. Layer Search on can help even if the walls to be trimmed are on the same layer.
#68986 by Roger D
Tue May 24, 2016 7:33 am
With 1 Line trim, sometime you need to make sure you are picking the control line of the smart wall.
If the z base/heights being different make it hard to clean.
Sometimes the wall may have an end with cap on, so when trimming the other end, it appears not to clean until you check that node and make sure cap is off.

Who is online

Users browsing this forum: Google [Bot] and 34 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984