I'm sure the "1" and "2" are attribute notations that are useful in some way, but I don't have the time to understand it right now and I need to turn them off. I can't figure out how. Can anyone help me out?
I have been thrown into the fire by my Architect supervisor. I went from a master bath renovation (something I am very familiar with from designing homes for over 30 years) to my second project... re-design an abandoned existing grocery store for new tenets. I am totally unfamiliar with commercial drafting, and totally unfamiliar with DC19. I'm the guy that went from DC8.05 to DC19. I am to get this party started in DC and save as DWG so he and others can work on it in AutoCad.
And I'm FREAKIN' OUT... Apparently there's a time limit on this thing.
I will continue to draw with the hopes that someone can chime in and tell me how to get rid of these things.
Thanks in advance
George
I have been thrown into the fire by my Architect supervisor. I went from a master bath renovation (something I am very familiar with from designing homes for over 30 years) to my second project... re-design an abandoned existing grocery store for new tenets. I am totally unfamiliar with commercial drafting, and totally unfamiliar with DC19. I'm the guy that went from DC8.05 to DC19. I am to get this party started in DC and save as DWG so he and others can work on it in AutoCad.
And I'm FREAKIN' OUT... Apparently there's a time limit on this thing.
I will continue to draw with the hopes that someone can chime in and tell me how to get rid of these things.
Thanks in advance
George