Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
#70890 by GARY247
Wed Mar 01, 2017 2:01 pm
I have three building sections a,b and c each in a different file. In section b I have an partial xref from section c in it. I open up section A and when i bring in section b for reference the internal xref from section c has disappeared. I have tried everything that has worked before and it still does not show up. I tried turning nesting and binding on and off in the different drawings with no luck. Does any have an answer as to how to solve this?
#70891 by MtnArch
Wed Mar 01, 2017 2:49 pm
Check the clip cube height? Check to make sure the layer in B that is referenced in in A is on?

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984