As you can see in the image below, I have drawn a Tuscan column for a project I'm drawing, and on the capitol, these small curves have disappeared. They have to still be there in some form because you can still see the center marks. What is going on? One side of one column was drawn initially, then mirrored, then copied all over the drawing file for multiple columns in multiple locations on the building, as well as multiple views (Front, side, rear, porch section detail, etc.) The first time it was only the astragal (180 degree curves), so I redrew them. Now every curve but the echinus has vanished (at the capitol... the torus at the base of the column is still there as well).
Any ideas? Is this a glitch in Datacad?
Any ideas? Is this a glitch in Datacad?