Is there anything within the macros to automatically generate bottom bearing open web wood joists?
Rod Walker (rodwalks@westnet.com.au) was working on a DrwTruss Macro that would do that, I have a demo that doesn't work any more.
Roger Donaldson AIA CSI CDT NCARB
abUsing Datacad since 1986, ver 23.00.02.15 (SE)
http://www.RogerDonaldsonArchitect.com
abUsing Datacad since 1986, ver 23.00.02.15 (SE)
http://www.RogerDonaldsonArchitect.com
Just a quick remembrance of Rod... he was deadly sharp in his macro programming for DataCAD. Anything that he did was as good and clean as anything could be. That macro that Rod mentioned was beautiful to behold. I'd like to be a tenth as good as Rod was.
He's missed.
Woody
He's missed.
Woody
Not sure but I am guessing that that macro is not available. Is this correct?
I doubt that Rod's family has any way to get that for you. He passed away several years ago so by now, all has probably been cleared away.
Woody
Woody
Who is online
Users browsing this forum: No registered users and 54 guests