When toggling between plan and elevation views the crosshair remains set at the last B-Tangents angle of the current view. If there are angled walls or a rotated plan and the crosshair is set at an angle, the crosshair remains at this B-tangent angle when switching to an elevation view. Similarly, if the crosshair is set at the pitch of a roof and the view toggles back to plan, the crosshair remains at the roof pitch B-tangents angle.
Wishlist - add view dependent crosshair angles (B-tangents) that allow a separate B-tangent view to be set up in both plan and elevation views. When each view is made active, the crosshair will switch to the angle set in that view.
Wishlist - add view dependent crosshair angles (B-tangents) that allow a separate B-tangent view to be set up in both plan and elevation views. When each view is made active, the crosshair will switch to the angle set in that view.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com