When I start DataCad the commands "Grid Snap , Disp. Grid 1 , Disp. 2" are on. Since I only occasionally use them, I turn them off.
But a couple of minutes later they are on again without any input from me that I am aware of. So I again turn them off. This is VERY, VERY, VERY, VERY, irritating and time wasteful.
Is there any way of turning these off so that they will stay OFF until I need them?
Thanks H. Hampton.
But a couple of minutes later they are on again without any input from me that I am aware of. So I again turn them off. This is VERY, VERY, VERY, VERY, irritating and time wasteful.
Is there any way of turning these off so that they will stay OFF until I need them?
Thanks H. Hampton.