Thought I'd try using smart entities on a small project. All was working fine and then I noticed all my flush wood doors no longer appear in o2c. in the door manager I can see the frame, stop and handles but no door. opened the symbol of the door and it is there with the proper material. It says in the manager the door is there but can't see it. Start a new file, insert the same exact door and works no problem. Tried importing the drawing into a new file and doors still did not appear. I had loaded some more doors after the missing door but that should not have been a factor. Any ideas. This is why I still don't use smart entities even after all these years! When I get time I will try and go thru all the steps and see when I lose that door. Thank you.
Dan
Dan
Dan Martens
NBF Architects
Rutland, Vermont
NBF Architects
Rutland, Vermont