1. Have your drawing on the screen and zoom extents, 2. Go to Print/MultiLayout/Layout - this displays a MSP sheet ready for you to place the drawing info onto, 3. Pick S2 Rotate, enter an angle (say 90'), and move your crosshair onto the sheet, left mouse-click to place and enter a detail name to finish, - done. 4. If you toggle S5 Extents Only, this will show either a bounding box or the actual drawing info you're placing on the screen, depending whether it's on of off, Hope this helps.
Thanks Mark. I was trying to rotate the drawing 8 deg 20 min in a clockwise direction. I was following your instructions and I couldn't get the rotation angle correct. In a moment of madness I tried adding a minus figure in front of the angle (ie -8.20.00) and all seems to rotate as I would have expected. Thanks again.