Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#76602 by mra
Mon Jul 01, 2019 9:06 am
With a self xref, the symbols on the primary drawngs do not appear, only the insertion marks
#76603 by MtnArch
Mon Jul 01, 2019 10:58 am
Are you using a Clip Cube or X-Clip? Check to make sure the Z-heights aren't outside of the limits.

Who is online

Users browsing this forum: No registered users and 0 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984