Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#76771 by dmartens
Tue Jul 23, 2019 2:25 pm
I know I have seen this discussed but I can't get it to work. I have a 3d slab drawn with a zbase of 1" and z height of 4". I insert my slab as a symbol to do an sclip on it. I go to 3d views, clipcube, set me zmin to 0 and max to 25'. I then sclip the symbol to get only the portion I want to show up and when I go to the object viewer the whole slab shows up. Can someone please tell me what I am doing wrong. This all ties into trying once again to start using smart entities. And once again I encounter a big stumbling block. Thank you in advance for any help.

Dan
#76778 by Mark Bell
Tue Jul 23, 2019 6:06 pm
Hi Dan,

O2C and Sunshader don't (yet) recognise Sclips or Xclips so the whole model/entity is displayed.
#76782 by dmartens
Wed Jul 24, 2019 7:09 am
Thanks Mark. That is unfortunate.

Who is online

Users browsing this forum: No registered users and 47 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984