When I mirror a plan the line work mirrors fine, but the left justified text from symbols and other notes ends up getting right justified which we then have to go back and justify it to left again. Is there anyway around this?
Not that I know of.
Thanks! - Josh
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned. (soon is a relative term)
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned. (soon is a relative term)
Perhaps consider setting all your symbol text as centre justified so when they get mirrored they remain the same.
joshhuggins likes this
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
And to add to Mark's suggestion, TTF's tend to mirror better than SHX fonts if that might be an option for you.
Thanks! - Josh
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned. (soon is a relative term)
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned. (soon is a relative term)
Who is online
Users browsing this forum: No registered users and 58 guests