Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#77466 by Roger D
Wed Jan 15, 2020 10:52 am
Is there a setting for when exporting to a .dwg, that all knockout attributes are removed from all polylines, even within symbol definitions.
#77468 by Mark Bell
Wed Jan 15, 2020 6:21 pm
Try the View pulldown/Knockouts then untick all the 3 options. Generally, ticking Compatibility Mode displays KO's in exported DWG's.
#77469 by Mark Bell
Wed Jan 15, 2020 6:24 pm
The other method could be to use Change/More/KO/NO, right click twice to go back to the Change menu then using EGAFM select the whole drawing to export, then exit the drawing without saving or pick undo to restore the KO's.
#77470 by Roger D
Wed Jan 15, 2020 7:19 pm
I could do that, but I don't think that would get rid of the old within the symbols where most exist.
#77471 by Mark Bell
Wed Jan 15, 2020 8:48 pm
You may need to Edit each symbol and remove then that way...or consider asking the recipient to turn off KO's at their end so they don't display on the software they're using?

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984