Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#78578 by joshhuggins
Sat Aug 15, 2020 4:13 pm
Is there a way to have a Symbol Attribute that is going to use Lookup to have a Default Value at Symbol insert? We used to be able to set the Value when using Lookup. Now when we set lookup, the value field becomes greyed out and it removes whatever is in the Value field. Symbol Attributes that were created before this change still work and load the what was set in the Value field as the time of their creation fine still.

It's just nice to have the most common or safest value, loaded by default first and then the lookup is available for a custom values from the databases if needed.

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for Architects Since 1984