Is there a way to break a dimension line when they cross one another like we used to do when we hand drafted?
You could create a small polyline rectangle, turn on knockouts, I would have the boundary show, but in a non printing color. Make sure it's in front of the dimension to break, but behind the line that is not broken.
Roger Donaldson AIA CSI CDT NCARB
abUsing Datacad since 1986, ver 23.00.02.15 (SE)
http://www.RogerDonaldsonArchitect.com
abUsing Datacad since 1986, ver 23.00.02.15 (SE)
http://www.RogerDonaldsonArchitect.com
Who is online
Users browsing this forum: No registered users and 24 guests