I'm in a situation where im attempting to switch details between clients that have different drafting standards... Is there a way to match font properties similar to "change>match>all" for linework? Otherwise im stuck spending a week or so of time just altering font properties. Thanks.
Doesn't Change/Text/Match All do it
Roger Donaldson AIA CSI CDT NCARB
abUsing Datacad since 1986, ver 23.00.02.15 (SE)
http://www.RogerDonaldsonArchitect.com
abUsing Datacad since 1986, ver 23.00.02.15 (SE)
http://www.RogerDonaldsonArchitect.com
I think you're looking for...
Change, Text, Match, Mask, Entity, Text, Text Mask.
From there you can specify...
-Text Search to look for a specific string (case sensitive or not).
- Font Search to look for a specific SHX or TTF font.
- Size Search to look for a specific size.
MFM
Change, Text, Match, Mask, Entity, Text, Text Mask.
From there you can specify...
-Text Search to look for a specific string (case sensitive or not).
- Font Search to look for a specific SHX or TTF font.
- Size Search to look for a specific size.
MFM
I have a custom toolbar pull-down for "match text properties" and "edit text". Indispensable! Next to that I have a Text pull-down for the various common text angles, "two-points" and text alignment.
I think I spend more time dimensioning and annotating my Datacad drawings than I do creating them.
I think I spend more time dimensioning and annotating my Datacad drawings than I do creating them.
Who is online
Users browsing this forum: No registered users and 13 guests