Mark F. Madura wrote:
(External) Batch Printing Setup Dialog
Here's the 'External' Batch Printing Setup Dialog. The Master PDF Filename you set here will be the name of the document that contains the output from all of the files in the 'set'.
Will there be an option to save the print drawing set where a series of external files have been loaded? This would save having to reload all the various drawings again when updates are due for printing, instead just load the SET file. You might also consider allowing multiple SET files to store various drawings which would allow a building to be broken down into the various components as per the drawing register then each can be stored and loaded and re-loaded as required for each round of updates and printing.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com