I had to replace my primary CAD PC a few months ago due to a catastrophic failure, so my Datacad 21 installation is new. I use Dir-Distance and Relative Polar coordinates mostly. I'm laying out a new site plan traced over an aerial photo so I'm constantly using Grid-Angle-Match to align with existing features. I can't get Datacad to make construction points <~> "tilde" using Dir-Distance with Ortho <O> on to indicate the Relative direction.....works fine in Rel. Polar. It also doesn't show a direction arrow...it does for other editting/drawing commands.
I think I'm missing or have forgotten a key step.
I think I'm missing or have forgotten a key step.