Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
Is there a way to save a symbol or ??? so that when the symbol is exploded the components will move to the correct (original) layers?
When you explode, the option should come up for:
Insert Layer or
Original Layers or
Roger Donaldson AIA CSI CDT LEED AP BD+C NCARB
abUsing Datacad since 1986, ver 21.03.02.00 (SE)http://www
Thank you very much!!! Forgot about this option!
Who is online
Users browsing this forum: No registered users and 2 guests