Use this forum to ask questions about DataCAD 20 and DataCAD LT 20.
#73708 by Glenn Curran
Tue Apr 17, 2018 2:46 am
I've been using a pre Retina Imac for 4 years or so with DataCad and now I'm considering replacing the machine with a 2017 5k model. However, I'm a little concerned that the text and icons in the DataCad menus will be too small to read with my poor old eyes. There is probably a way to increase the "visibility" of these bits and pieces and still retain sharpness, but I'm pretty hopeless at all this technical stuff. Has anyone been through this? Any advice is much appreciated. Thanks.
#73710 by Glenn Curran
Tue Apr 17, 2018 8:07 am
Thanks for the response, Neil. At the moment I'm on W7 with Dcad 12, but if I get the new machine I will be on W10 with Dcad 20 LT, as I understand that Dcad 12 won't run with W10. Ill take a look at that thread, thank you.
Regards
Glenn

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984