Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#74996 by Bob Urbanek
Thu Oct 11, 2018 12:57 pm
Something happened -again. I have been using the same method to dimension since DCAD5. Didn't change anything. When I dimension something, the witness line would stay anchored where I snapped to and I would drag the dimension line down to where I wanted it.Now the witness line is offset considerably from where I snapped to. I have tried to change settings, and I can't fix it. What am I missing? I can go to older drawings, and it still works correctly. Any suggestions?
#74998 by Roger D
Thu Oct 11, 2018 1:32 pm
Maybe Fixed Incr. got turned on under Dim. Style
#75020 by Bob Urbanek
Fri Oct 12, 2018 12:25 pm
Thanks Roger and Josh,
After I posted yesterday, I just got frustrated and shut down for a few hours. When I started up again, the problem was gone. ?????
Thanks for your help.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984