Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#75341 by GARY247
Mon Dec 10, 2018 5:26 pm
So what do I have to do to make a symbol stay revised. If I reload it it reverts back to the old one.
Last edited by GARY247 on Mon Dec 17, 2018 12:01 pm, edited 1 time in total.
#75348 by GARY247
Tue Dec 11, 2018 9:07 am
Josh
I was wrong. I was looking in the wrong place. It was under symbol tools. No it is not clicked. Yesterday I revised the same symbol 4 times and each time it failed to be stay revised. I had the same problem in another drawing where the symbols changed from one drawing to another. In that case I think it was reacting to symbols in the drawing it self with the symbol file changing instead of the symbols in the drawing. I think it might be the case in my current drawing. How do I get the symbol file to stay and the drawing get updated? Should I have auto reload turned on so all other symbols in the drawing are updated to the revised one?

Who is online

Users browsing this forum: No registered users and 0 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984