Ever wanted to know how to perform a specific operation? Ask the experts.
#76326 by seasdes
Wed May 01, 2019 10:04 pm
Can an edge of a void align with an edge of a master slab/polygon. Or do I need to add vertices's to an edge of a slab/polygon
#76330 by Mark F. Madura
Thu May 02, 2019 10:19 am
I recommend using Covered Polylines, and voids can be coincident, overlapping, or completely outside of the master boundary. You can also put a 'notch' in one edge of the master boundary instead of making the void coincident with it.
#76335 by dhs
Thu May 02, 2019 3:12 pm
voids can be coincident, overlapping, or completely outside

Just be aware that if you use DataCAD to get the area (or perimeter or volume) of a polyline with overlapping or outside voids the result may not be what you expect:
DataCAD will simply subtract the area (or volume) of the void from the area of the main polyline even if the void is not completely within the main polyline (or add the perimeter of the void to the perimeter of the main polyline even some of the edges of the void are coincident or outside of the main polyline).

Who is online

Users browsing this forum: Majestic-12 [Bot] and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984