Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#77054 by tlarso
Sat Oct 05, 2019 12:28 pm
I wish to change the wall height of a smart wall. The default is 8' and I would like to change it to 10' but am unable to. Any help in making changes to smart wall heights would be appreciated.
#77055 by Roger D
Sat Oct 05, 2019 12:55 pm
a couple ways.
Change Z-height to 10, but the key is to also change the z-base to 0, otherwise changing the height just pulls the wall up 2'.
or
double click on the wall and change the properties, height to 10' making sure the base at 0.
or
If you have another wall with the correct height, Change\Match All.

Who is online

Users browsing this forum: No registered users and 4 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984