Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#77255 by Lars
Fri Nov 15, 2019 2:19 pm
So I'm drafting along.... minding my own business, and all of the sudden DC slaps me in the face with not allowing my CTRL+Z to undo my previous command. Has a resolution to this issue been discovered?

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984