What features would you like to see added to a future version of DataCAD?
#77592 by Mark Bell
Thu Feb 13, 2020 11:21 pm
I'm hoping these additions to the existing smart doors DTM aren't too difficult to implement and will allow the plans to show greater detail for improved coordination as the scale zooms in. Rather than just a rectangle for the door frame, a symbol of an actual door frame can be used and if scale-dependent symbols are also used, then these can change to the actual manufacturer profile at at close-up detail scale, allow quicker documentation for plan details and cross referencing. Showing door handles also helps coordinate door types and clearances. Similarly, improving the flexibility of display on swing line types can allow doors to be placed for other building elements such as o/h or u/b joinery/cupboard doors etc.
021420door.jpg

Who is online

Users browsing this forum: No registered users and 24 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984