Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#77613 by Gary24752
Wed Feb 19, 2020 10:41 am
When I insert an xref or self-xref all I am seeing is the clip cube. I have checked display and program functions and cannot seem to get the xref to show. The active layer is not locked. I have never had this issue. What do I have to do to get it to show?
#77614 by Neil Blanchard
Wed Feb 19, 2020 1:21 pm
Hi Gary, I may be wrong, but I don't think we can see the entire XRef / Self Reference during insertion. It shows the extents box, and inserts by the center. The work around is to place it, and then snap to move it a specific distance.

I think that some / many XRefs would just be too big to show smoothly.
#77622 by dmartens
Thu Feb 20, 2020 4:16 pm
If you are seeing the clip cube Ctrl-rt click on the clip cube box, xref tools, xclip and F1 turn off clip cube. Then the entire xref should show.

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984