Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#77749 by rdberry
Wed Mar 18, 2020 7:00 pm
when I use the 2d3d casework template or the 3d stairs,
and try to go to elevations or the hide command, all I get is a single line.
This is only on one drawing that I'm working on. However,
I tried to copy those cabinets to another drawing that
worked with the 3d stairs. When i hit elevations, they still
came up a straight line.
I'm sure there is a setting that i hit and can not find.
Any suggestions.
Thanks
Robert " Butch Berry
architect
Eureka Springs, AR .
#77750 by Mark Bell
Thu Mar 19, 2020 5:50 am
1. Maybe check the Projection Pad has Ortho (Plan view) selected as it could be set to a 3D view such as Parallel/Iso etc.?
2. Also turn off any clipcubes that may be on.
3. Identify the line and if it is "hundreds of kilometres" long, delete it, then regen the drawing.

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984