What features would you like to see added to a future version of DataCAD?
#77813 by Mark Bell
Thu Apr 02, 2020 1:14 am
There appears to be 2 options with smart wall hatching - either have the hatch a consistent direction relative to the drawing screen or set to match the wall angle. The problem arises if the smart walls are rotated 'odd' angles which results in the hatching either staying at the same angle relative to the drawing screen, or if match wall angle is on, the hatch angle is retained for each separate wall as shown below. It can also result in some walls not displaying any hatching due to the wall and hatch angles aligning.

Wishlist - add a Lock Hatch Angle so the hatch remains consistent across all walls even when the walls are rotated rather than having the hatch angle remain fixed.

040220a.jpg
040220a.jpg (93.4 KiB) Viewed 777 times

preference to have Match Wall Angle deselected

040220b.jpg

Match Wall Angle deselected and walls rotated with hatch remaining fixed relative to drawing screen - would prefer the option to have the hatch also rotate with each wall

040220c.jpg

Match Wall Angle selected but results in hatching being in various directions on a per wall basis

Who is online

Users browsing this forum: No registered users and 16 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984