Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#78495 by Mark Bell
Mon Aug 03, 2020 4:28 am
Hi Bob,

The last used smart wall/door/window type remains current independent of the layer. Using Alt + I over a smart entity makes that current. From memory, it's always been this way.

If you open the Layer Manager, down the bottom are 4 options to tick allow each layer to remember the Z-b/Z-h, Material, Line type and Line spacing on a per layer basis. ....not sure if this helps you though.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984