Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#79109 by Bob Urbanek
Fri Nov 27, 2020 12:59 pm
I brought up an old drawing and saved it as new to edit it and create a new plan . Everything was working normally until I went to insert a saved symbol. It came in at a humongous scale. Can't figure out how to rectify this. It would seem that some setting got changed, but I don't know what. Any ideas?
Bob
#79110 by Roger D
Fri Nov 27, 2020 1:26 pm
Symbol Scale might be turned on. This option is available at S5 after you have selected the symbol to insert.
#79111 by Bob Urbanek
Fri Nov 27, 2020 6:11 pm
Thanks for the reply, Roger. Yeah, I had tried that. Strange, when I insert the symbol, it comes in 9 times the size that it should be. I tried another symbol, and it also came in super sized.
Just don't get it.
#79112 by Roger D
Fri Nov 27, 2020 7:13 pm
I assume you have also checked the symbol in large isn't set to nine?
#79114 by Roger D
Sat Nov 28, 2020 12:22 pm
I meant symbol enlarge, the setting at F4 after you have selected the symbol to insert.

Who is online

Users browsing this forum: No registered users and 4 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984