Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#79237 by Roger D
Sun Jan 03, 2021 2:36 pm
You could create a small polyline rectangle, turn on knockouts, I would have the boundary show, but in a non printing color. Make sure it's in front of the dimension to break, but behind the line that is not broken.

Who is online

Users browsing this forum: No registered users and 18 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984