Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#79377 by Bob Kreger
Sun Feb 21, 2021 1:36 pm
Been going steady for months on version " 21.03.08.00 (PE) ".... (whatever PE is...)
Suddenly the hatch command is crashing the aec file.
I tried using Hatch in a new blank file. It crashed even a new empty aec file.
I even used the File Repair function - no change.
Sounds like I should reinstall DCAD?

Any ideas?
Bob
#79378 by MtnArch
Sun Feb 21, 2021 2:31 pm
Is it only with one certain hatch pattern or with all of them? Even Dcad's standard hatch patterns?

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984