- Right-click on your DataCAD 19 program icon and select Properties.
- On the Compatibility tab click Change high DPI settings.
- In the High DPI scaling override section check Override high DPI scaling behavior.
- In the Scaling performed by drop-down, select Application.
- Click OK.
This should prevent Windows from 'stretching' DataCAD's interface.
Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
Note: Primary Monitor Dpi Awareness was first supported in DataCAD 20.01.00. Mixed-Mode Dpi Awareness (per-monitor) was first supported by DataCAD 21.03.08. Prior to 20.01.00, If the Display Scale for the 'primary' monitor is set to 100%, then it should be unnecessary to override High Dpi Scaling.
Mark F. Madura
Who is online
Users browsing this forum: No registered users and 1 guest