I'm working on the project, left the computer which powered down, and had to restart. The window came up with following message:
"File was not closed properly, DataCAD will now recover the most recent version of this file."
I click OK and a window came up with teh following message:
"DataCAD (internal diagnostics) fault 9 error from:736"
I click on OK and the cursor just keeps spinning non-stop.
Whats going on, I cant open my file!!
Jack
"File was not closed properly, DataCAD will now recover the most recent version of this file."
I click OK and a window came up with teh following message:
"DataCAD (internal diagnostics) fault 9 error from:736"
I click on OK and the cursor just keeps spinning non-stop.
Whats going on, I cant open my file!!
Jack