Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#72942 by architektone
Wed Dec 20, 2017 5:54 pm
I'm working on the project, left the computer which powered down, and had to restart. The window came up with following message:

"File was not closed properly, DataCAD will now recover the most recent version of this file."

I click OK and a window came up with teh following message:

"DataCAD (internal diagnostics) fault 9 error from:736"

I click on OK and the cursor just keeps spinning non-stop.

Whats going on, I cant open my file!!


Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984