Do any of you have a clever trick to establish viewpoint and view angle? When I F2 to walkthrough, I pick an elevation view, then set "perspective" then enter the model. At some point, I want to increase the view angle to 90 degrees or so to approximate a very wide angle lens, but that blasts me right through the model. I wish I could change view angle without changing viewpoint.
Hmmm.. just a beginner... but wondered if you have tried right clicking when your in the walk around mode, gives you glasses. It allows you to look up, down, left right without blowing out of the model. Not 90 degrees but gives you eyes.. control to see the interior.